There are several different types of air quality permits depending on the type of activity and emission rates of air pollutants. The following list explains each different type of permit.
Class I Permits
Class I permits are issued to any source that meets the requirements of Arizona Administrative Code (A.A.C.) Title 18, Chapter 2, Article 302(B)(1) . Such sources include:
- Any Major Source - A "Major" source as defined by the A.A.C. Title 18, Chapter 2, Article 101(64) is any source that has the potential to emit 100 tons per year of any criteria air pollutant . A source is also considered major if it has the potential to emit 10 tons per year of any single Hazardous Air Pollutant or 25 tons per year of any combination of Hazardous Air Pollutants.
- Any Affected Source - An "Affected" source as defined by the A.A.C. Title 18, Chapter 2, Article 101(5) is a source that includes one or more units which are subject to emission reduction requirements or limitations under Title IV of the Clean Air Act .
- Solid Waste Incinerations Units - Subject to Section 129(e) of the Clean Air Act.
- Any source in a source category designated by the Administrator pursuant to 40 CFR 70.3 and adopted by the director by rule.
Class II Permits
Class II permits are issued to sources that do not qualify for Class I permits and that meet the requirements of A.A.C. Title 18, Chapter 2, Article 302(B)(2) . Such sources include:
A general permit is a pre-approved permit and certificate that covers a specific class of sources. A general permit differs from an individual permit in that it can be applied to more than one source, is usually more restrictive, less expensive, and requires a shorter period of time for the processing and issuance of an Authorization to Operate (ATO). By the issuance of a general permit, the Department indicates that it approves the activities authorized by the general permit, provided that the owner or operator of the source, registers with the Department and meets the requirements of the general permit.
When a source applies for coverage under an individual permit it must go through its own public notice and possibly a public hearing. Since the general permit is written to cover sources that are similar, it must go through public notice and public hearing only once. Each source that is covered by the general permit will not be required to go through its own public notice and public hearing. However, a list of sources that have been covered under the general permit will be published periodically. This publication will be the public's only notification that a specific source has been given coverage under the general permit.
Once a general permit has been developed, sources may apply for coverage under the general permit instead of obtaining individual permits. If the sources meet the criteria for coverage under the general permit, an Authorization to Operate (ATO) is issued for each major piece of equipment covered under the permit. The ATO allows for easy tracking of permitted equipment and assists inspectors in verifying coverage while conducting inspections.
Download the following general permits:
- Crematories (Expires November 30, 2014)
- Soil Vapor Extraction Units (Expires June 30, 2016)
- Crushing and Screening (Expires April 23, 2017)
- Hospitals (Expires November 14, 2014)
- Hot Asphalt Plants (Expires April 23, 2017)
- Dry Cleaners (Expires July 19, 2016)
- Generators (Expires July 19, 2016)
- Concrete Batch Plants (Expires June 08, 2015)
- Boilers (Expires May 12, 2014)
- Air Curtain Incinerators (Expires April 17, 2019)
Title V Permits
Title V is a portion of the 1990 Clean Air Act Amendments , which outlines the Operating Permits Program. The Operating Permits Program was made into law to uniformly limit the emissions from major sources of criteria air pollutants throughout the United States. This requires states to implement permit programs at least as stringent as federal requirements to avoid federal sanctions. A default federal permit program is implemented in those states that fail to implement their own federally-approved permit program, ensuring that all major sources must comply with the applicable federal Clean Air Act regulations. The federal U.S. Environmental Protection Agency (EPA) has the power to overrule state permit decisions to ensure compliance.
Under Title V all major sources must apply to the state in which the source resides for an air quality control permit. These sources must submit plans showing compliance with all the applicable Clean Air Act regulations. The state must then review the plans and application for compliance and subsequently draft a permit. The permit must be reviewed by the appropriate regulatory agencies, nearby states (when applicable), and by the U.S. EPA.
Arizona has received interim approval for the federal Title V permit program, established by the 1990 federal Clean Air Act Amendments. The interim approval of the ADEQ Title V program became effective on Nov. 29, 1996.
More information about the Title V permitting process can be found at the U.S. EPA Clean Air Act Operating Permits Program .
Prevention of Significant Deterioration (PSD) and New Source Review (NSR)
As mandated by the Clean Air Act, new major stationary sources of air pollution and major modifications to existing sources must obtain air quality control permits before starting construction. When sources in attainment areas apply for such permits, they are referred to as PSD permits. Sources that are in non-attainment areas apply for such permits, they are referred to as non-attainment area NSR permits.
The main goals of attainment area PSD regulations are designed to ensure that:
- To ensure that economic growth will occur in harmony with the preservation of existing clean air resources.
- To protect the public health and welfare from adverse effects which might occur even at air pollution levels better than the national ambient air quality standards.
- To preserve, protect, and enhance the air quality in areas of special natural recreational, scenic or historic value.
The main goals of non-attainment area NSR regulations are designed to ensure that:
- A new source's emissions will be controlled to the greatest degree possible.
- More than equivalent offsetting emissions reductions will be obtained from existing sources.
- There will be progress toward achievement of attainment status.
For more information on PSD/NSR Permits, see Title 18, Chapter 2, Article 4 of the Arizona Administrative Code .
Open Burn Permits
Unless specifically exempted by the rule, persons setting outdoor fires must obtain a permit from ADEQ or a delegated permitting authority. Two types of open burn permits are issued in Arizona: Normal and Dangerous Materials.
Normal Open Burn Permits
Needed for open outdoor fires for the purposes of weed abatement, prevention of a fire hazard or instruction in the methods of fighting fires.
In some locations, fire departments and local governments have authority to issue normal open burn permits. To obtain a normal open burn permit in these areas, contact the appropriate local agency for a permit application and filing instructions. See following list to determine the appropriate permitting authority for your burn location.
Dangerous Materials Open Burn Permits
Needed to burn hazardous waste or any substances that may cause bodily harm or property loss if not neutralized, consumed or otherwise disposed of in a controlled and safe manner. Fires set for the disposal of dangerous materials are permitted only when there is no safe alternative method of disposal and when the burning of the materials does not result in the emission of hazardous or toxic substances in amounts that will endanger health or safety.
Only ADEQ has authority to issue open burn permits for dangerous materials.
For more information or to apply, please Contact Us.